Wilden pump suction pipe diameter shall be not less than the diameter of the pump inlet end, such as the transmission of high-viscosity fluids, suction pipe diameter is preferably greater than the wilden pump inlet diameter. The inlet end of the suction pipe must be durable, no wrinkles, to be able to produce a high vacuum state. Tsshe diameter of the outlet pipe is at least equal to the outlet diameter, or slightly larger in order to reduce friction losses. All piping and fittings must be leak proof seal, otherwise the pump will reduce the ability to self- absorption.
Pneumatic diaphragm pump installation: should ignore the details of the installation, for a long time of careful planning, research and selection may still lead to poor pumping effect and impact pump life. Location: noise, safety and other logical factors usually the equipment should be installed position requirements. Installed in parallel conflicting requirements may lead to the blocking of the use of regional impact to other pump installation.
Use: First, the position of pneumatic diaphragm pumps must be easy to use, so that maintenance personnel will facilitate routine inspection and debugging.
Gas supply: Each pneumatic diaphragm pump should have a snorkel, and snorkel should be able to provide the amount of air is sufficient to achieve the desired pumping flow. Pressure different pumping needs, but not to exceed 7BAR.
Mounting height: Please give full consideration to the ability to avoid self-priming pneumatic diaphragm pumps to reduce the problem of self- absorption.
No comments:
Post a Comment